[vadimus_ca]

Сообщение от Codex

А как вы себе это представляете, если там DVD с декодером на борту?

В цифре (DTS) только звук передается, и то только в усилителе на Паджеро.

Передается аналоговый сигнал.
Тот же фокус, что и с АУКсом, просто активируется другая кнопка.

Естественно, управления при этом никакого не будет.

Добавлено через 7 часов 36 минут
Нашел распайку:
http://www.mitsu-wiki.com/wiki/Secon..._Stereo_Wiring

C-18/C-19
2nd gen outlander c-19.png
C-18 is a spare connector on the non-NAV versions of the Outlander. It is taped up when no navigation unit is present, but can be used for aftermarket stereos. Of particular note is pin 63, which can activate the rearview camera view on stereos.
C-18 (C-19 with NAV)
Pin Description
45 Rear display video signal (MMCS to rear) (to D-16 pin 35)
50 Chassis Ground
51 Constant +12V
56 Rear display A/V (MMCS to rear) (video ground for pin 45)
57 Rear display A/V (video ground from rear DVD player to MMCS)
58 Rear display A/V (video signal from DVD player to MMCS)
63 Reverse signal (+12V when in reverse)
This is called C-101 on the Outlander RVR. Starts from pin 1 instead of 41, where pin 23 is reverse wire.
NOTE: You can use the video output from pin 45 and 56 to make an MMCS video out RCA connector. Likewise, you can use 57 and 58 to get video to the MMCS (aux video in). The audio will come from the AUX IN audio from the connector below.
C-14/C-15
2nd gen outlander c-14.png
C-14 (C-15 with NAV)
Pin Description
1 IE+ Bluetooth/FUSE/USB (with FUSE system only) pin 2
2 SH-A Bluetooth/FUSE/USB (with FUSE system only) pin 23 (request control of audio?)
3 Right channel audio from Bluetooth/FUSE/USB (with FUSE system only) pin 22
4 Right channel AUX in (right channel from rear DVD to MMCS as well)
5 Satellite radio (shielded ground)
6 Satellite radio (Right Channel)
7 To RF AMP (power or CAN?) and rear A/V (D-06 pin 14)
8 Radio panel faceplate control (CAN BUS)
9 Radio panel faceplate control (CAN BUS)
10 IE- Bluetooth/FUSE/USB (with FUSE system only) pin 16
12 Left channel audio from Bluetooth/FUSE/USB (with FUSE system only) pin 8
13 Left AUX in (left channel from rear DVD to MMCS as well)
14 AUX ground (rear display audio in ground as well)
15 Satellite radio (Left Channel)
17 VCC RF AMP (spliced to provide power to FUSE if equipped pin 15)
18 Radio front panel power
This is called C-105 on the Outlander RVR (C-106 with NAV). Note: You can make a secondary AUX in by using the satellite radio pins above if you have satellite radio module but do not use it.
FUSE System
FUSE is available on 2010+ model year cars. They can be retrofitted to the older Outlanders (custom wiring required) with the purchase of the latest generation 6cd changer/MMCS. It is plug and play to add to 2010+ Outlanders. For FUSE module pinout, see here. Note the FUSE module pin 17 to GND, 14 to MIC+, 28 to MIC-, 27 to SH-M (mic power?), 1 to VCC, 15 to ACC
C-16/C-17
2nd gen outlander c-16.png
C-16 (C-17 with NAV)
Pin Description
21 +12V ACC
22 Steering wheel controls (+)
23 CAN BUS
24 To AMP/speaker
25 To rear right hand speaker positive (no AMP)
26 To amp/speaker (front right positive)
27 To rear left hand speaker negative (no AMP)
28 To AMP/speaker (front left positive)
29 Illumination/lights on (+12V when active)
30 +12V
31 Speed sensor (+12V when car moving)
32 Steering wheel controls (-)
33 CAN BUS
34 Antenna Amplifier
35 To rear right hand speaker negative (no AMP)
36 To AMP/speaker (front right hand negative)
37 To rear left hand speaker negative (no AMP)
38 To AMP/speaker (front left hand negative)
40 Notes:Ground