Информация из сервис мануала MY 2016 (стр.2-31)
http://faq.out-club.ru/download/outl...-KD_PDI&PM.pdf
CHANGE ENGINE OIL
1. Start the engine and allow it to warm up until the
temperature of the coolant reaches 80 °C to 90
°C.
WARNING
Use care as engine oil could be hot.
2. Remove the engine oil filler cap.
3. Remove the engine oil pan drain plug to drain
engine oil.
4. Install a new engine oil pan drain plug gasket and
then tighten the engine oil pan drain plug to the
specified torque.
Tightening torque: 39 ± 5 N⋅m
5. Refill with specified quantity of engine oil.
Specified engine oil:
• ACEA classification: A1/B1, A3/B3, A3/B4
or A5/B5
• ILSAC classification: ILSAC certificated
oil
• API classification: SM or higher
Total quantity (Includes volume inside
engine oil filter and engine oil cooler):
• <4B11>
• <Vehicles without engine oil cooler>
4.3 L
• <Vehicles with engine oil cooler> 4.4 L
• <4B12> 4.6 L
• <6B3> 4.3 L
NOTE: SAE 0W-20*, 0W-30, 5W-30, and 5W-40
engine oils can only be used if they meet ACEA
A3/B3, A3/B4 or A5/B5 and API SM or higher
specifications.
NOTE: *: Vehicles to comply with the Euro 4 regulation
6. Install the engine oil filler cap.
7. Let the engine run for a few minutes.
8. Stop the engine, and then check the engine oil
level using the engine oil level gauge after a few
minutes.
Никаких ограничений по 3.0 нет, все точно также как и на 3.0 2013 года.
Читайте сервис мануалы, там более чем достоверная информация.